2005 Ford Expedition, Ford F-250, Ford F-350 TICKING AND/OR KNOCKING NOISE...
download FORD: 2005 Mustang 2004-2005 F-150 2005 Expedition, F-250, F-350 This article supersedes TSB 05-15-8 to update the Service Procedure. ISSUE Some vehicles equipped with a 4.6L 3-valve or 5.4L...
View Article2002 Kia Spectra SENDING UNITS & SENSORS LOCATION
download Air Quality Sensor At center front of engine compartment. Camshaft Position Sensor On rear of cylinder head. See Fig. 1 . Chassis Acceleration Sensor At right rear side of engine compartment....
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View ArticleFord / Mercury / Lincoln Band-Mounted Sensor Re-Learn Instructions
The instructions below can be used for the following vehicles: 2008 Ford Crown Victoria / Lincoln Town Car / Mercury Grand Marquis 2008 Ford E-series 2007-2009 Ford Edge / Lincoln MKX 2005-2008 Ford...
View Article1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article1991 Ford Thunderbird Crankshaft Position Sensor Service and Repair
download 1. Disconnect the negative battery cable. 2. Disconnect the crankshaft sensor electrical connectors from the engine wiring harness. 3. Raise vehicle and support properly. 4. Remove the upper...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
